Researchers have created a new kind of plastic material that could help electronics function in extreme heat.
The new plastic material could reliably conduct electricity in up to 220 degrees Celsius (428 F), according to a paper in Science.
“Commercial electronics operate between minus 40 and 85 degrees Celsius. Beyond this range, they’re going to malfunction,” says Jianguo Mei, an assistant professor of organic chemistry at Purdue University. “We created a material that can operate at high temperatures by blending two polymers together.”
One of these is a semiconductor, which can conduct electricity, and the other is a conventional insulating polymer, which is what you might picture when you think of regular plastic. To make this technology work for electronics, the researchers couldn’t just meld the two together—they had to tinker with ratios.
“One of the plastics transports the charge, and the other can withstand high temperatures,” says Aristide Gumyusenge, a graduate researcher and lead author of the paper. “When you blend them together, you have to find the right ratio so that they merge nicely and one doesn’t dominate the other.”
The researchers discovered a few properties that are essential to make this work. The two materials need to be compatible to mix and each should be present in roughly the same ratio. This results in an organized, interpenetrating network that allows the electrical charge to flow evenly throughout while holding its shape in extreme temperatures.
The most impressive thing about this new material isn’t its ability to conduct electricity in extreme temperatures, but that its performance doesn’t seem to change. Usually, the performance of electronics depends on temperature—think about how fast your laptop would work in your climate-controlled office versus the Arizona desert. The performance of this new polymer blend remains stable across a wide temperature range.
“A lot of applications are limited by the fact that these plastics will break down at high temperatures…”
“A lot of applications are limited by the fact that these plastics will break down at high temperatures, and this could be a way to change that,” says Brett Savoie, an assistant professor of chemical engineering. “Solar cells, transistors, and sensors all need to tolerate large temperature changes in many applications, so dealing with stability issues at high temperatures is really critical for polymer-based electronics.”
The researchers will conduct further experiments to figure out what the true temperature limits are (high and low) for their new material. Making organic electronics work in the freezing cold is even more difficult than making them work in extreme heat, Mei says.
Source: Purdue University