While investing in new, cheap ATV tires now and again is always an excellent idea for those looking for a balance of safety and performance on the road, it’s important to your wallet to make the tires you have last as long as they’re able. That means learning to repair them. While knowing how to patch a standard tire is par for the course for many bikers, handling tubeless motorcycle tire is an entirely new game. Fortunately, there is a way to go about it, and this guide can point you in the right direction.

Plugging Is the Way to Go

There are many little ways to temporarily repair a tubeless flat, but if you’re looking for a permanent fix, then plugging your tire is the way to go. Plugs handle the problem from the inside, where it has a better chance of surviving road conditions and friction. This method is the only one that completely fills and seals puncture holes.

Before Beginning

Before getting started with your tire repair, there are a few things you’ll want to know. Firstly, not every puncture wound can be repaired. If your puncture happens to be on the very edge of the tread or in the sidewall, you won’t be able to repair it using this method. Holes larger than 7mm in diameter are also untreatable by this method. Second, you’ll require a set of specific tools in order to perform this task on a motorcycle. Most standard motorcycle tire repair kits will come with the parts you need, and it’s always wise to keep one on hand.

Fixing Your Tire

Once you’ve gathered your materials and tools, it’s time to get started with repairs.

  1. Mark the puncture and then remove the item.
  2. Dismount the tire.
  3. Inspect the tread/inner liner for damage (bubbling will require tire replacement).
  4. If your tire doesn’t need replacing, buff the inner liner until fresh rubber is exposed. The buffed area should be slightly larger than the patch piece in your repair kit.
  5. Clear the hole of debris.
  6. Apply a healthy layer of rubber cement to the area you’re repairing and allow it to dry for a few minutes.
  7. Free the patch head of its covering and push the pointed side through the hole (from the inside). It should fit flush with the inner liner you’ve buffed.
  8. Trim the quill so it’s flush with your tread.
  9. Push the patch into place and displace any air underneath it.
  10. Replace the tire on your bike and restore proper air pressure.

After you’ve completed your repairs, retest the seal using the soap method, and recheck the plug job after you’ve driven a few miles to ensure it’s holding up properly.

This is the best, most permanent way to repair your tires, but not every tire is fixable. If you continue to experience leaks, it’s likely time to invest in a replacement. Simply search “motorcycle tires near me” in your preferred search engine to find the right fit for your ride.

No one likes to slow down for repairs, but fixing your problem should always be your first approach. Get your tires plugged up and ready to move today so you can get back on the road.

LEAVE A REPLY

Please enter your comment!
Please enter your name here